PLC的三面铣组合机床控制系统

范文编号:ZD722    范文字数:2672,页数:11

摘要

 本文在分析现代常用的三面铣床组合机床控制系统的基础上，提出了一种基于可编程控制器（PLC）作为主控设计方案，并完成了硬件和软件设计。该控制系统具有稳定性高、适应性强、成本低等优点，经模拟调试，完全符合工作要求。
 
关键词：三面钻组合机床 PLC 控制系统 软件设计

Abstract

 This article in the analysis modern commonly used three milling machine aggregate machine-tool control system's foundation, proposed one kind (PLC) takes the master control design proposal based on the programmable controller, and has completed the hardware and the software design. This control system has the stability to be high, the compatibility is strong, the cost low status merit, after the simulation debugging, meets the work requirement completely.
 
 key word: Three facing set aggregate machine-tool PLC control system software design
 
 
 
目录
摘要 I
Abstract I
目录 II
引言 1
一、三面铣组合机床概述 1
1.1 基本结构 1
1.2 加工过程 2
1.3 液压系统 3
1.4 主要电器参数 4
1.5 三面铣组合机床的控制要求 4
二、控制系统的设计 4
2.1硬件设计 4
2.2系统控制回路的设计 5
2.3系统梯形图 6
结论 9
参考文献 9

 《PLC的三面铣组合机床控制系统》WORD格式全文下载链接